ESU SwitchPilot 3, 4-way magnetic decoder, DCC/MM, OLED, with RC feedback, updateable – item 51830

SwitchPilot 3 decoders are optimized for stationary use on your system and can switch conventional double-coil switch drives, light signals, magnetic uncouplers, light bulbs or other stationary consumers. In order to make the configuration, which was previously rather complicated with magnetic decoders, easier, the SwitchPilot 3 has an innovative operating concept, consisting of a 4-line, illuminated OLED display and three input buttons.

Operating modes

The SwitchPilot 3 is multi-protocol capable and can be used with control panels based on the Märklin® Motorola® system (e.g. 6021, Central Station® or Mobile Station®) as well as DCC-capable control panels. The configuration can take place on both the main track and the programming track. Thanks to RailCom®, CVs can also be read.

functionality

The SwitchPilot 3 can be powered either directly from the digital system or from an external direct or alternating voltage source. It has a total of 8 transistor outputs, which are grouped in the 4 output pairs 1 to 4. Each output pair contains two outputs (OutA and OutB) and can be individually configured for the desired application: In pulse mode, the output is switched on as soon as a switching command is received. The fact that the output automatically switches off again as soon as the time stored in the decoder has expired prevents the magnetic device drives from burning out. In momentary operation (K83 compatible), the output remains active as long as the button on the control panel is pressed. This operating mode is suitable for point drives with limit switching or for uncoupling tracks. In bistable continuous operation (k84 compatible), the two outputs are switched on and off alternately: When you press the first button (red) on the control panel, the output Out A is switched on. It remains active until the output Out B of the same output group is activated by pressing the assigned button (green). Out A and Out B behave like a toggle switch. In alternating flasher mode, the outputs Out A and Out B of an output pair are switched on alternately with an adjustable flashing frequency. The alternating flasher is started with the “Straight/Green” command of the assigned button and stopped again with the “Branching/Red” command. Optionally, the output can also be slowly faded up and down (so-called “zoom” for light bulb simulation).

Return message

Since the SwitchPilot 3 is RailCom®-capable, all settings can be read and changed directly when installed if desired. In conjunction with an ECoS as an ideal “partner”, the SwitchPilot 3 can record and display the actual switch position with appropriately prepared switch drives. Finally you have the certainty that your switch has switched correctly!

Set

The SwitchPilot 3 can be flexibly set either on the programming track with DCC centers or on the main track with POM (“Programming on Main”) or can also read out CVs using RailCom®. If desired, it can also learn the addresses directly using a programming button. The easiest setting is of course with the integrated OLED display and the three input buttons: All (!) settings can be checked directly on the decoder and changed if desired. “Programming” with the help of your control center is not necessary. It really couldn’t be easier. The ESU LokProgrammer can be used for firmware updates.

Protection

As with our locomotive decoders, the outputs of the SwitchPilot 3 are largely protected against overload. We want you to enjoy your decoder for as long as possible.