ESU – LokPilot micro V4.0 8-pin NEM 652 with harness item: 54683

LokPilot micro V4.0, 8-pin NEM 652 with harness

Item: 54683

This decoder is a genuine power house. It drives the loco motor with a continuous load capability of 0.75A and has significantly shrunk compared to its forerunner: the smallest member of the LokPilot V4.0 family has now a size of only 10.5mm x 8.1mm x 2.8mm and should thus fit in the smallest N-/TT-gauge locos.

Key features:

• The LokPilot micro V4.0 commands Motorola® and Selectrix® as well as DCC through 14, 28 and 128 speed steps or can be used on analogue DC layouts. You can either use 2- or 3-digit (1 – 127) as well as 4-digit (1–9999) addresses or assign a consist address.

• From a LokPilot decoder, you rightly expect an excellent motor management. With the LokPilot micro V4.0, ESU introduces the once more improved fifth generation of load control. The standard frequency is adjusted to the speed with a basic frequency of 40 kHz.

• The LokPilot mirco V4.0 decoder has 2 function outputs which achieve 150 mA load each. They can be allocated individually to different functions. There are two further unamplified outputs which can be also used for both light or special functions.

  All important light functions as available, such as flashing light, firebox flicker, strobe – and double strobe, Ditch Light etc. The brightness of each output can be adjusted separatly

• All function outputs and the motor connection are overload and short-circuit protected.

• The firmware on LokPilot decoders can be updated. This means you are able to replace the internal decoder software by a newer version, if needed. You only need an ESU LokProgrammer to do so.